1934_接收機增益自動控制電路的設計

1934_接收機增益自動控制電路的設計,接收機,增益,自動控制,電路,設計 黃 河 科 技 學 院 畢 業 設 計 說 明 書 第 I 頁接收機增益自動控制電路的設計摘 要自動增益控制電路已廣泛用于各種接收機、錄音機和信號采集系統中，另外在光纖通信、微波通信、衛星通信等通信系統以及雷達、廣播電視系統中也得到了廣泛的應用。本課題主要研究應用于無線接收機的前級電壓放大，因此設計的電路需容納的頻帶范圍應較寬，以至于使語音信號通過。由于信號的脈沖寬度是 0.3 微秒，重復頻率1.875 千赫茲，幅度波動范圍是 1.5-3.0 伏，電路應該實現增益的閉環調節，通過此電路可以實現增益的自動調整，以至于使視頻信號強時自動減小放大器的倍數，信號弱時自動增大放大器的倍數，從而實現信號的自動調節。本課題介紹了自動增益控制的概念原理以及對自動增益控制放大器各部分的工作原理，最后對系統的測試結果以及設計與實現中應該注意的問題也做了詳細分析。關鍵詞： 放大器；自動增益控制； 電壓跟隨器； 濾波器黃 河 科 技 學 院 畢 業 設 計 說 明 書 第 II 頁The design of receiver automatic gain control electric circuitAuthor:Xia Jian xin Tutor:Wang Fei AbstractThe automatic gain control electric circuit has been widely used in all kinds of receivers、tape recorders and signal gathering systems, and also been used in communications system radar, the broadcast television system and optical fiber communications, microwave communications, satellite communications.This topic mainly studies to the applies to the front level voltage amplification of the audio frequency amplification, therefore the frequency band scope of the electric circuit should be wider that can make the pronunciation signals to pass. Because the frequency band scope of the pronunciation signal is 0.3 microseconds, so the frequency band scope of our electric circuit should be designed within 1.875 KHz. And the electric circuit should realize the closed loop adjustment between 1.5 volt and 3.0 volt which increases, it may realize the automatic control through this electric circuit which increases when the tonic train signal is strong automatically that it can reduce the multiple of the amplifier, and when the signal is weak that it can automatically increase the multiple of the amplifier , so that can realize the volume with automatic control.This topic also introduced in the concept principle of the automatic gain control as well as to automatically increases the amplifier every part of principle of work the detailed introduction, and it pays attention to the question to the test result of this system .Finally we have make some analysis to the design.Key words：Amplifier； Automatic Gain Control； Voltage follower；Filter 黃 河 科 技 學 院 畢 業 設 計 說 明 書 第 III 頁目 錄緒論 .11 自動增益控制11.1 自動增益控制電路（AGC）存在的意義 .11.2 自動增益控制的基本概念.21.3 自動增益控制的原理 31.4 自動增益控制放大器.41.5 本課題的研究?jī)?nèi)容 .52 自動控制電路增益的計算62.1 自動控制增益計算 .62.2 主要性能指標.72.3 電路類型.92.4 可控制增益放大器103 自動增益控制放大器的電路設計 143.1 電路原理圖 .143.2 電路元器件選擇144 輸出信號波形圖.214.1 主放大器基本原理214.2 主放大器214.3 自動頻率控制電路（907、928 組合）284.4 波形圖29結論.31致謝 .32參考文獻.34